How do I fix the code on my Traeger?

According to Traeger technical support, “LEr” is an error code that appears on the control display when your grill operates for 10 consecutive minutes without reaching 125°F (regardless the set temperature). It will likely occur if you’ve left your grill open, or have run out of pellets.

According to Traeger technical support, “LEr” is an error code that appears on the control display when your grill operates for 10 consecutive minutes without reaching 125°F (regardless the set temperature). It will likely occur if you’ve left your grill open, or have run out of pellets.

Additionally, why did my Traeger caught fire? My Traeger caught fire. The main reason this happens to me is because there is too much ash stuck on the bottom of the fire pot and it causes the heating rod to not properly judge how many pellets are in the pot.

Also question is, what causes LEr on Traeger?

If a LEr error code has appeared on your display of a grill, it means the temperature of the grill is less than 125 degrees Fahrenheit. It may happen if you set it for a low and slow smoke, or maybe you ran out of pellets or they are too dusty and the fire pot is too dirty and stuffed.

Why is my Traeger not getting hot?

Poor airflow in the grill, which can be caused by too much ash buildup in the firepot, rusted holes in the firepot, a tightened chimney cap, a weak induction fan, or the RTD temperature probe inside the grill is dirty or leaning towards the body of the grill.

What temp should my Traeger smoke at?

There is no temperature control with the “Smoke” setting. This timed cycle setting for “Smoke” is a factory pre-set recommended by Traeger Pellet Grills to develop a “Smoking” temperature of 150 to 180 degrees F.

Why does my Traeger temperature fluctuate?

Wood pellet grills are going to fluctuate in temperature. This is completely normal. This occurs in your electric home ovens and it will occur on your grill. Ensure shutdown mode was used at the end of the last cook.

What is the RTD on a Traeger?

The RTD Temperature Sensor reads the internal temperature of the grill, communicating with the controller to maintain consistent grill temperatures. The Replacement, 7” (178mm) RTD temperature is simple to install and compatible with all full sized Traeger grill models.

How do I clean my Traeger drip tray?

Published on Mar 15, 2019 Spray grates with the Traeger All Natural Grease Cleaner. Spray inside of chimney. Remove and clean grates with the Wooden Grill Grate Scrape. Remove drip tray liner. Remove drip tray. Remove heat baffle. Vacuum inside of grill. Scrub inside of chimney with a bottle brush.

How long is the Traeger shutdown cycle?

Traeger Grill Shut Down Cycle After you are done cooking, turn the grill to the Shut Down setting on the controller and allow the 10 minute Shut Down Cycle to complete. The induction fan will shut off automatically after 10 minutes. After the induction fan shuts off, turn the power switch to the off position.

What if Traeger runs out of pellets?

Your Traeger Pellet Grill should never be moved while it is hot. If you run out of pellets and lose your fire while cooking, let the Grill completely cool and start again with the INITIAL FIRING INSTRUCTIONS. 5) CAUTION! Make sure the Heat Baffle is properly seated on its locating brackets.

What does er1 mean on a Traeger grill?

ER1-OPEN/LOOSE CONNECTION ON RTD. ER2-SHORT CIRCUIT /DEFECTIVE RTD.

How long does it take for Traeger to heat up?

10 minutes