How do you reset the oil light on a 2011 Prius?

04-09 Prius procedure

How to Reset Toyota Prius “Oil Change” or “Maintenance Required” Light

  1. Step 3: Press the Power button once to power your Prius down.
  2. Step 4: Press and hold down the ODO button and press the Power button twice (2X) with your foot off the brake.

Subsequently, question is, how do I reset my Prius? 04-09 Prius procedure With foot on brake, push power button and hold the power button in for 30 seconds. Release power button and try to restart. All should be OK, car starts, warning lights off, and all PCM’s re set. Repeat if not successful.

Also asked, how do you reset the oil maintenance light on a 2010 Toyota Prius?

2010-2015 Toyota Prius Oil Maintenance Required Light Reset:

  1. Turn the ignition to the ON mode without starting the engine.
  2. Press the TRIP button repeatedly until you see “TRIP A” on the display.
  3. Next, turn OFF the ignition.
  4. Press and hold the km/h MPH button while turning the POWER button to ON mode again.

How do I get my Prius to stop beeping?

Method 1 of 3: Disabling the Reserve Alarm in a Generation 2 Prius

  1. Start the car.
  2. Press the Trip button until ODO shows then turn the car off.
  3. Start the car again.
  4. Press and hold the TRIP button for 10 seconds.
  5. Step on the brake and shift into reverse.
  6. Shift back into park.
  7. Re-engage the reverse beep.

How do I reset my oil change?

Some cars will flash the word “Reset,” or display the numeral “100” to show that 100 percent of oil life remains after the oil change. Turn the ignition off, wait a few moments, and then start the engine. Look at the dash to see if the oil light is still flashing or lit. If so, repeat the reset process.

How do you reset the maintenance light on a 2006 Toyota Prius?

To reset the oil maintenance light press the display until it reads the odometer reading, turn the power switch off, press the power switch to ignition on while holding down the trip meter reset button, keep the trip reset button held down for about 10 seconds , the display will read 000000 and then the light will go

How do I reset my dashboard?

How to Reset the Warning Lights on the Dash Open the hood of your vehicle. Loosen the nut that holds the negative terminal to the battery with the pliers. Completely remove the cable from the negative battery terminal. Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.

Why is my maint reqd light on?

The maintenance required light is notifying you that maintenance is required according to the driven distance on the vehicle’s maintenance schedule. Most often this just means your vehicle might be due for an oil change.

How do you fix a maintenance required light?

Toyota Maintenance Required Light Turn the key to the on position. Next, determine that the odometer reading is displayed. Then turn the key back off. Now push and hold the reset button for the trip meters. Finally, while continuing to depress the reset button, turn the key back to the “on” position, but not so far as the “start” position.

What does red triangle mean on Toyota Prius?

Common Causes. Many Prius drivers have reported the most common cause for a red triangle of death light is an issue with their battery. When this code appears, the problem is typically caused by several sources, but it means there is an issue with the HV battery’s ECU.